Synthetic Gear Oil CY150 with High-temperature Resistance

Ứng dụng sản phẩm:It is applicable to lubrication of heavy-duty industrial gears at medium and low speed, sliding and rolling bearings, and air compressors. Compared with mineral gear oils, it has high efficiency, low power consumption, low wear, long service life, and lon

Giới thiệu sản phẩm

Amer Synthetic Gear Oils CY150, CY220 & CY320 with High-temperature Resistance


Performance overview:

This product is prepared by using high-quality synthetic oil as base oil and adding additives that are resistant to oxidation, wear and rust. It is used for bearings and gears under harsh conditions where mineral oil cannot be used.

Major advantages:

       

1. Comprehensive protection for equipment: with outstanding lubricity and wear resistance, it can withstand heavy loads and give the equipment the longest service life.

    

2. Excellent lubrication effect: it is featured by corrosion resistance, excellent oiliness, high bearing capacity, and its performance is much better than that of high-grade mineral oils, giving equipment lasting lubrication.

    

3. Wide application range: this product has a good stability at high temperature, with service temperature range from -40 to 200℃, as well excellent fluidity at low temperature and good viscosity-temperature property, enabling the machine to start at low temperature easily.

4. Keep the equipment clean: it has high flash point, low volatilization and long-term use at high temperature without coking and precipitation, effectively save lubricating oil and improving working conditions, without environmental pollution.

 

5. Long service life: it can be used at high temperature up to 200℃, with service life 3-5 times of traditional mineral oil.


 

Main Application:

     

It is applicable to lubrication of heavy-duty industrial gears at medium and low speed, sliding and rolling bearings, and air compressors. Compared with mineral gear oils, it has high efficiency, low power consumption, low wear, long service life, and long oil change interval.


 

Precautions:

      

1. When applying this product, the part to be lubricated shall be cleaned to avoid contamination.

2. It shall not be mixed with greases of other grades or varieties, due to poor compatibility with other oils.

3. Do not mix with used lubricating oil.


 

Typical features:


ISO Viscosity Grade       150             220            320      
Specific gravity, g/cm3 1.01 1.01 1.01
Kinematic viscosity, mm2/s (V40℃) 156 228 330
Kinematic viscosity, mm2/s (V100℃)    23.3 31.5 42.1
Viscosity index 180 182 183
Pour point, ℃ -42 -43 -43
Flash point (open-cup), ℃ 266 270 272